TPU PPF for Ford Maverick 2022-2024 HD Clear Paint Protective Film Custom Fit Anti Scratch Self Healing Shield Guard with Install Kit Finishing Accessories for Bumper Headlight Fog Light

Paintville TPU PPF for Ford Maverick 2022-2024 HD Clear Paint Protective Film Custom Fit Anti Scratch Self Healing Shield Guard with Install Kit Finishing Accessories for Bumper Headlight Fog Light

• 【Tailored】: Customized for Ford Maverick 2022 2023 2024.This option includes the front bumper , fog light and headlights. Accessory kit included waterproof instruction manual,spray bottle,high fiber towel,felt squeegees,utility knife and magnetic holder
• 【Car Care Essentials】：Protect your car's paint from wear and tear Headlight film also slows down surface deterioration. With Headlight Protection from Paintville your MAVERICK's lights will be able to shine bright for years to come
• 【About TPU】：Combines the physical durability of plastics and the flexibility of rubber. It maintains high strength and elasticity across a wide temperature range, boasting excellent optical clarity and resistance to yellowing.The films shield paintwork from scratches, swirl marks, UV rays and acid rain for 5-10 years, and even facilitate self-healing of minor blemishes and defects over time.
• 【About Installing】: ① Clean the car and then dry with a clean towel. Make sure to remove dirt and grease. ② Create a slip solution by mixing approximately 15% neutral detergent and 85% water in a spray bottle . And make sure the solution is mixed. ③ Spray the mounting area and front of the film , then remove the film from the backing and spray the backside . ④Using magnetic holder to assist with installation. ⑤ Use the squeegee to remove any air bubbles between the film and paint.
• 【Note】：①、Do not allow any portion of the film to hang off the edge of the vehicle.②、If you accidentally get sand, gravel, or dust during installation, you can rinse it off by spraying it with a lubricant.③、 Spray enough slip solution as needed, and you can push lightly with your fingers to align the film with the mounting location. ④、The LH and RH film pieces are not interchangeable; the sticky backing should be applied to the paint of the car and follow the contour of the body. NOTE BEFORE PURCHASE: In order to avoid installation deviation, there is no pre-cutting for trailer hitch/sensor/logo location. Please use a hobby knife to trim after installation