Remote Receiver Cover Heat Shield for Gas Logs and Fireplaces by Midwest Hearth

Insulated Metal Remote Receiver Cover Inside dimensions measure 2.5"w x 1-3/8"h x 2.25"d The MHRRCM is a protective cover for your remote receiver. The cover is not only attractive, but it also protects the electronics of the receiver from heat generated by your gas fireplace. Installation Instructions: Place the MHRRCM onto the remote control receiver. Make sure you have followed the recommended location of the receiver according to the manufacturer's/homeowner's manual. Failure to do so may cause overheating of your receiver and/or reduce the battery life due to the potential for a higher operating temperature. Make sure the insulation is in place and surrounds the remote receiver. Note: Make sure that you do NOT route the reciver wiring near the burner, flame, or other high temperature surface. *The MHRRCM does not make your receiver heat-proof. If provides additional protection, but you must still properly locate your remote receiver according to your appliance's instructions.

• All metal construction lined with insulation
• Cut-outs provided on back and side for routing wiring
• Provides additional protection against heat
• Inside dimensions measure 2.5"w x 1-3/8"h x 2.25"d
• Heat shield only, receiver not included