New Throttle Control Cable BullWhip for Gas Powered Compressor 24

Conrader Throttle Controls are used to regulate the engine speed on gas engine-driven compressors in continuous run operation. These controls are used in conjunction with a pilot valve and an unloader valve. When the compressor reaches the unload (cut-out) pressure the pilot valve sends a pneumatic signal to the throttle control which actuates and extends to reduce the engine speed. As the compressed air is used and the compressor reaches the load (cut-in) pressure the pneumatic signal is discharged by the pilot and the throttle control retracts to return the engine to normal operation speed. Using a throttle control will save fuel and extend the life of the compressor and engine. Conrader Cable Style Throttle Controls are mounted on the pilot valve or elsewhere on the compressor and the cable end is connected to the engine throttle arm. These are of brass construction with viton seals, stainless steel springs, and stainless steel cable. The cable is permanently lubricated and is self cleaning. Routing clamps are used to mount and protect the cable. Min Actuation Pressure: 80 PSI __ Max Operating Pressure: 500 PSI __ Operating Temperature Range: -15f to 400f __ Inlet Connection: 1/8" Male NPT.

• Throttle Control Mechanism for 8 HP and smaller Gas-Powered Engines
• Throttle Control designed to be used in conjunction with a pilot device
• Cable does not have to be straight in order to function
• Cable Lenght is 24 inches
• Valve Thread size is 1/8" Male NPT