HTLNUZD Flysky FGR8B 2.4GHz 8CH Remote Control Receiver, Output AFHDS 3 PWM/PPM/i-Bus RF Modules Compatible FS PL18 / Noble NB4 Pro / NB4 Lite/ FRM302 Transmitters for Rc Car Boat

Binding instruction and hard update firmware❶Put the transmitter into bind mode.❷The binding process is complete when the LED on the receiver stops flashing and is on continuously.❸ Press and hold the receiver BIND button [11] while powering on the receiver, release the BIND button after receiver is powered on, the LED [12] on the receiver will flash rapidly.★If a transmitter that has had its radio frequency (RF Standard) set to “AFHDS3 1 way” (please refer to your transmitter user manual)enters bind mode, the receiver LED will instead flash slowly. Exit bind mode on the transmitter and if the receiver LED stops flashing and is on continuously, the binding process is complete.❹Check to make sure the transmitter and receiver functions are working correctly, repeat steps 1 to 3 (binding process) if any problems ariseHard update firmware☛If after a firmware update is performed and the transmitter is unable to bind to the receiver, the receiver may need to be put into forced update times.☺ Power on the receiver while pressing the BIND button [11] for then approximately ten seconds until the LED [12] flashes three times, release the BIND button.☺ Go to the RX Setup menu on your transmitter and select“RX Update”.☺When the receiver LED flashes slowly, the update is successful.Product Model: FGr8BAdaptive transmitter: all transmitter supporting AFHDS3 (PL18, NB4, NB4 Lite, etc.)Model Type: Car/Boat ect.PWM Channels: 8RF: 2.4GHz2.4G Protocol: AFHDS 3 Antenna: Single AntennaInput Power: 3.5-9VData Output: PWM\PPM\i-businTemperature Range: -10℃—+60℃Humidity Limit: 20%-95%Package:1 x FGr8B Receiver

• 【size & weight】1.37*0.91*0.52 inch (35*23.3*13.3mm) Weight: 9.4g.
• 【Good compatibility】Compatible with all AFHDS 3 transmitters and RF modules including PL18, NB4, NB4 Lite, FRM302, etc.
• 【High configuration】The FGr8B receiver adopts Flysky's third-generation automatic frequency hopping digital system (AFHDS 3).
• 【Convenient storage】With a compact size and light-weight, no worry to give any burden to your RC Model, Very convenient for storage and storage.
• 【Data Output】It uses a single-antenna bidirectional transmission system and is uniquely designed to install and output PWM/ 8 Channels，/PPM/i-bus in signals.