Class A Customs 13 Gallon Water Tank & Plumbing Kit T-1300-BPK

FRESH/DRINKING WATER SAFE – MADE IN THE USA by Class A Customs using NSF Certified Materials Tank & fittings made from DOW NSF International NSF/ANSI Std 61 approved Medium Density Polyethylene (MDPE) Resin. OEM PART No retail box, no install instructions. Have a certified technician install all parts to prevent product damage and personal injury. FOOD VENDORS, BEFORE PURCHASING, verify all requirements with health department where inspection will be made. SEAMLESS one-piece construction, no seams to burst. CREAMY WHITE COLOR you can see waterline through tank. PREPARATION Tanks are made in a warehouse clean each tank prior to use to remove any debris, scuffs or marking from the manufacturing process. MOUNTING & BRACING Place tank on level surface and brace to prevent tank from moving during transit. DO NOT hang tank by straps. DO NOT place weight on tank. TANK MUST BE VENTED allowing air in and out when in use. *DO NOT PRESSURIZE TANK* do not make a sealed connection from garden hose directly to tank damage will occur. DO NOT over-tighten fitting damage will occur, use plastic connecting fittings as metal will damage threads. TANK BUILT-IN FITTINGS (SEE PHOTOS) 1.5" Female NPT Fitting - fitting is sealed and watertight, to use remove membrane with razor knife (SEE PHOTOS) .5" Female NPT Fitting - fitting is open

• 13 Gallon Fresh or Gray Water Holding Tank Manufactured by Class A Customs - Made from NSF Approved Materials - Fresh & Drinking Water Safe - Can be used for Fresh or Gray Water Storage
• 13 GALLON TANK MEASUREMENTS 21” x 9” x 16”- Tank can sit on any side - rotate tank to change height or width Average Thickness 7/32” +/- Please view photos. (Due to the manufacturing process +/- .25" on each measurement)
• TANK BUILT-IN FITTINGS: (TWO) 1.5" Female NPT Fitting - fitting is sealed and watertight, to use remove membrane with razor knife (TWO) .5" Female NPT Fitting - fitting is open DO NOT over-tighten fitting damage will occur, use plastic connecting fittings as metal will damage threads.
• NON-PRESSURIZED TANK: tank must be vented allowing air in and out during use. DO NOT make a sealed connection with a garden hose directly to tank, this is a pressurized connection and will cause tank to explode causing damage. For filling tank it is recommended to use a fill dish or other gravity process.
• BASIC PLUMBING KIT INCLUDES - (TWO) 0.5” Hose Barb to 0.5” Male Pipe Thread Adapter (FOUR) 0.5” Hose Clamp (ONE) 1.25” Hose Barb to 1.5” Male Pipe Thread Adapter (TWO) 1.5” Hose Clamps (ONE) 1.5” Male Pipe Thread PVC Male Adapter (ONE) 5ft. Section of 0.5” ID Vent/Draw Hose (ONE) 5ft. Section of 1.25” ID (1.375” OD) Fill Hose