Chimney Fan, 50W/60W/100W Fireplace Exhaust Fan Flue Fan Chimney Draft Inducer Chimney Exhaust Fan for Fireplace Black(1pc),100W

- These fans should be installed at the termination point of a solid fuel chimney or stack system and can be mounted on masonry or metal chimneys.- Chimney Fan is for use where flue gas temperatures do not exceed 575 F for intermittent operation, and 482 F for continuous operation.Specification:Product name: Electric Draft Inducing FanVoltage: 190-240VInstallation method: Install the induced draft fan on the chimney exit, run a cable in a suitable place in the room and connect it to a single 220V power supply. (Please turn off the device when installing or removing to avoid electric shock.)Note:1. Turn off the power switch when installing or removing to avoid electric shock.2. The interface to the smoke outlet must be fastened with waterproof insulating tape.3. The installation at the interface with the chimney must be firm and the interface must be tightly integrated into the chimney for the best effect.Package Included1 *Induced draft fan

• It is very suitable for chimney accessories. The chimney induced draft fan generates suction and induces the rapid discharge of smoke to prevent the smoke from being unable to exit the flue smoothly due to the poor chimney.
• Electric Draft Inducing Fan Help Exhaust Fireplaces, Pizza Ovens, Wood Stoves, Chimney Fan for Flue Diameter 9-12cm/13.5-14.5cm/23-24cm.
• This Type of Induced Draft Fan is Used on Household Chimneys /Fireplace , and the Outlet Temperature Should Not Exceed 80 Degrees. The Induced Draft Fan Should Be More Than 6 Meters Away from the Fire Source.Otherwise the Induced Draft Fan Will Be Burnt.
• Easy to install, very quiet, suitable for most types of chimneys, and does not require professional technicians to install. Not only will the smoke be discharged quickly, but it also has excellent performance.
• The operating voltage of the product is 220V( 110V-120V voltage, we will be equipped with a voltage converter), and the chimney induced draft fan is used by leaving two ends of the wire for connection to the power source.