Adjustable Clamp-on Gate Hinge Pair by Bullet Fence Systems

Effortlessly hang gates on pipes with these clamp-on, adjustable gate hinge pairs, featuring an optional J bolt. No welding or drilling required, making installation quick and simple. Choose from one-way or two-way bands, and select your post size with or without threaded J bolts, accommodating either 5/8" or 3/4" diameters. Each kit includes galvanized components, with one-way kits containing 4 one-way brace bands, 4 carriage bolts, 8 hex nuts, 2 weld tabs, and a J bolt if selected. Two-way kits include 4 two-way brace band pairs, 4 carriage bolts, 8 hex nuts, 2 weld tabs, and a J bolt if selected. Sold in pairs to hang one gate. Installation involves measuring and marking locations, assembling brackets, and securing the gate using the provided hardware. The gate clamp is not included, as it typically comes with the gate purchase.

• Kit Contents: 4 one-way brace bands, 4 carriage bolts, 8 hex nuts, 2 weld tabs, 4 two-way brace band pairs, 4 carriage bolts, 8 hex nuts, 2 weld tabs
• Initial Setup: Measure and mark locations for post j bolts, ensuring ground clearance for gate swing
• Assembly: Attach carriage bolt to band and j-bolt plate, then repeat for other ends and assembly
• Two-Way Band Installation: Position assemblies on post at marked height, attach other halves of band, and secure with nuts
• One-Way Band Installation: Slide brackets over post to marked height, open center hole towards gate direction, and secure with nuts
• Secure Bands: Tighten outside nuts to clamp bands to post
• Install J-Bolts: Thread nuts and washers onto bolts, insert into plate hole, and adjust for gate leveling
• Attach Gate: Place gate female clamp into bottom j-bolt assembly, lift gate, slide up clamp into j-bolt, and tighten
• Final Adjustments: Secure clamps and make any necessary adjustments to gate swing